|
|
|
|
Micrometer types
(click below for details)
|
|
Every micrometer and bore gauge includes the following display functions allowing
metric or imperial measurement, tolerance checking, minimum, maximum and ovality
measurements, and statistical calculations suitable for statistical process control
applications...
|
Basic Display
The basic display mode is shows measurements in millimeters or inches, absolute or
relative to a datum value. Any measurement can be held, allowing the component to be
removed without disturbing the display.
|
|
Limit Mode
Limit mode shows the limits of the spindle movement, i.e. the maximum and minimum
measurements. It can be used in a variety of applications, such as checking a shaft
for ovality or taper.
|
|
Tolerance Mode
The display in this mode will indicate whether the current measured value is above,
below or between two previously programmed tolerance limits and allows rapid sorting
of good and bad parts.
|
|
Statistics Mode
This mode calculates the statistical results below from measurements taken each time
you press the HOLD button. You can plot SPC charts straight from the display!
- Number of measurements entered
- Average (Mean)
- Standard Deviation
- Range
- Maximum and Minimum
|
|
Calibration Mode
This mode is used to set offsets, comparator values and tolerance values either directly
from reference standards or independently from the tool's operating buttons.
|
|
